ZEPHYRO

 Methods of application
Surface preparation
Sandpaper and dust any imperfections with STUCCOMURO and apply 1 coat of FISSATIVO UNIVERSALE which should be correctly diluted with water at a ratio of 1:5 up to 1:10 according absorption of the surface.
Leave to dry for at least 4 hours and apply 1 or 2 coats of PRIMER S, which is special slightly rough either white or slightly colored, correctly diluted ( consult the Technical data sheet) leaving 4 to 5 hours between each coat. (photo 1).
Application
Spread a layer of ZEPHYRO with a SPALTER DECORA' tool on the surface (photo n.2) ) by using irregular movements
like cris crossing brush marks (photo n.3). The brush marks can also be vertical, horizontal or oblique it all depends on the finish you wish to obtain.
1 coat of ZEPHYRO is normally sufficient in order to a perfect coverage of the surface.
The ZEPHYRO finish can be clearly seen when the entire surface has completely dried about 4 to 5 hours after the application